Sony HCD-551 - Dubbing Tapes from Deck A to B; High Speed Dubbing Procedure; Dubbing Notes and Settings

Dubbing
Tapes
(from
Deck
A
to
9)
This
section
describes
about
the
operation
of
the
recording
from
deck
A
to
B.
3 Press HIGH SPEED DUBBING.
The unit enters recording pause mode for high speed
dubbing, the Il and indicators light.
(Dubbing can not be carried out without pressing
HIGH SPEED DUBBING.)
HIGH SPEED
DUBBING
Select the side on which to start dubbing.
To dub from the front side, press >.
To dub from the reverse side, press <J,
Press 11 on deck B to start dubbing
The recording pause mode will be canceled and
dubbing starts.
PAUSE
1 Press & to open the cassette compartments,
insert the tapes and close the cassette
compartments.
Recorded tape Blank tape
The Ill indicator goes off.
To stop dubbing, press Ml on deck A or deck3.
Notes
* The tape in deck B is automatically recorded with the same
recording system as the original tape in deck A. So it is
unnecessary to adjust the recording level and selecting the
DOLBY NR.
* If the sound is affected by a television set during dubbing,
turn off the set or move it away from the unit.
2 Select the direction mode.
== C3 RELAY
DIRECTION
js
“| st CS RELAY Dubbing of the
reverse side
starts
DIRECTION independently
> <Geme of deck A.
== CD RELAY Dubbing of the
Teverse side
starts
DIRECTION simultaneously
nt od with deck A.