Sony HCD-GR5 - MECHANICAL ADJUSTMENTS; Precautionary Measures and Torque; ELECTRICAL ADJUSTMENTS; Deck Section Adjustments

— 11 —
Azimuth Adjustment
Tape Speed Adjustment
Level Adjustment
Used for
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads pinch rollers
erase head rubber belts
capstan idlers
2. Demagnetize the record/playback head with a head
demagnetizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
Torque Measurement
SECTION 4
MECHANICAL ADJUSTMENTS
DECK SECTION 0 dB=0.775V
1. Demagnetize the record/playback head with a head damagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to the
parts adjusted.
4. The adjustments should be performed with the rated power supply
voltage unless otherwise noted.
5. The adjustments should be performed in the order given in this
service manual. (As a general rule, playback circuit adjustment
should be completed before performing recording circuit
adjustment.)
6. The adjustments should be performed for both L-CH and R-CH.
7. Switches and controls should be set as follows unless otherwise
specified.
DOLBY NR switch: OFF
FWD
REV
REV
back tension
FF/REW
FWD tension
CQ-102C
CQ-102C
CQ-102RC
CQ-102RC
CQ-201B
CQ-403A
CQ-403R
2 to 6 g • cm
(0.02 - 0.08 oz • inch)
36 to 61 g • cm
(0.5 - 0.84 oz • inch)
2 to 6 g • cm
(0.02 - 0.08 oz • inch)
61 to 143 g • cm
(0.85 - 1.99 oz • inch)
100 g or more
(3.53 oz or more)
100 g or more
(3.53 oz or more)
FWD
back tension
REV tension
Torque Torque meter Meter reading
36 to 61 g • cm
(0.5 - 0.84 oz • inch)
SignalTape
P-4-A100
WS-48B
P-4-L300
10 kHz, –10 dB
3 kHz, 0 dB
315 Hz, 0 dB
Record/Playback Head Azimuth Adjustment
(Deck A, Deck B)
Note: Perform this adjustments for both decks.
test tape
P-4-A100
(10kHz, –10dB)
MAIN board
CN403
Pin
3 (L-CH)
Pin
1 (R-CH)
set
MAIN board
CN403
Pin
2 (GND)
level meter
+
–
SECTION 5
ELECTRICAL ADJUSTMENTS