Sony HCD-GS30DAB - MAIN Board; REG Board, WIRE HOLD Board

10
HCD-GS10/GS30DAB
1 screw(+BVTP 3 × 8)
5 screw (+BVTP 3 × 8)
3 screw (+BVTP 3 × 8
)
6 REG board
2 WIRE HOLD board
4 coating clip
3-9. REG BOARD, WIRE HOLD BOARD
3-8. MAIN BOARD
WIRE HOLD board
1 connector
(CN001)
9 MAIN board
3 two screws
(+BVTP
3 × 8)
7 connector
(CN103)
5 connector
(CN201)
6 connector
(CN202)
2 wire (flat type)
21core (CN114)
8 wire (flat type)
11core (CN113)
4 Remove the two harnesses
that is fixed on the clamp.
When assembling,
clamp the two harnesses with
a lead pin.
PRECAUTION DURING
CONNECTOR INSTALLATION
lead pin
harness
harness
MAIN board
(UK)
Ver. 1.2