Sony HT-CT800 - Bluetooth Settings Configuration; Bluetooth Mode and Device Management

55
GB
Using the Various Functions/Settings
[On]: The system reproduces the dolby
sound track with the kind of dynamic
range that the recording engineer
intended.
[Off]: No compression of dynamic
range.
[Audio Output]
You can select the output method used
for audio signal output.
[Speaker]: Outputs multi-channel sound
from the system’s speakers only.
[Speaker + HDMI]
: Outputs multi-
channel sound from the system’s
speakers and 2-channel linear PCM
signals from the HDMI OUT (ARC) jack.
When [Control for HDMI] is set to [On]
(page 56), [Audio Output] is set to
[Speaker + HDMI] automatically and this
setting cannot be changed.
[Sound Effect]
You can turn on/off the sound effect
such as the sound field.
[Sound Field On]
: Enables all sound
effects.
[DTS Neo:6 Cinema]/[DTS Neo:6 Music]:
Performs DTS Neo:6 Cinema/Music
mode decoding. For 2 channel source,
the system simulates surround sound
from 2 channel sources and produces
multi-channel sound. For multi-channel
source, the system outputs sound from
the speakers depending on the number
of channels of the source.
This item can be selected only when
using the wireless surround function.
[Bluetooth Mode]
You can enjoy content from a
BLUETOOTH device by using this system
or listen to sound from this system by
using BLUETOOTH-compatible
headphones.
[Receiver]
: This system is in receiver
mode, which enables it to receive and
output audio from the BLUETOOTH
device.
[Transmitter]: This system is in
transmitter mode, which enables it to
send audio to the BLUETOOTH-
compatible headphones. If you switch
the input of the system, “BT TX” appears
on the front panel display.
[Off]: The BLUETOOTH function is turned
off and you cannot select the [Bluetooth
Audio] input.
You can connect to a BLUETOOTH
device* by using the One-touch function
even if you have set [Bluetooth Mode] to
[Off].
* Only mobile devices such as a
smartphone, tablet, WALKMAN®
[Device List]
Displays a list of paired and detected
BLUETOOTH devices (SNK device) when
[Bluetooth Mode] is set to [Transmitter].
[Bluetooth Standby]
You can set the [Bluetooth Standby] so
that the system can be turned on by a
BLUETOOTH device even when the
system is in standby mode. This
function is only available when you set
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: The system turns on automatically
when you request a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off
[Bluetooth Codec - AAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: Enable AAC codec.
[Off]: Disable AAC codec.
Note
Note
[Bluetooth Settings]
Note