UsingtheSleep Timer
You can set the receiver to turn off
automatically at a specified time.
Press SLEEP repeatedly while the
power is on.
Each time you press tile button, the display
changes cyclically as follows:
2-00-00 ---+ 1-30-00 --+ 1-00-00 --+ 0-30-00
-+ OFF
When sleep timer is activated, the display
clims.
Note
If you press any buttons on the remote or receiver
after the display dims. the disphly brightens up.
After a while, the display dims again if no button is
pressed.
Tip
To check the remaining time before the receiver
turns off, press SLEEP. The remaining time appears
on the display. If you press SLEEP again, the sleep
timer will be canceled.
Changingbutton
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
player to the VIDEO 1 jacks on the receiver,
you can set the VIDEO 1 button on this remote
to control the DVD player.
1 Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO 1.
2 Referring to the table below,
press the corresponding
button for the category you
want,
Example: Press 4.
Now you can use the VIDEO 1 button to
control the DVD player.
9
O
I'D
I'D
3
continued_
53G8
To Next Page
