Sony HT-XT3 - Bluetooth Settings

25
GB
HT-XT3
4-558-561-13(1)
D:\NORM'S JOB\SONY HA\SO150002\HT-XT3 (PMRF 02)\4558561131_GB
(CEK)\050SET.fm
masterpage:
Right
Settings and Adjustments
 [Bluetooth Mode]
You can enjoy contents from remote
device by using this system or listen to
sound from this system by using other
device such as headphones.
[Receiver]
: This system is in receiver
mode which enables it to receive and
output audio from the remote device.
[Transmitter]: This system is in
transmitter mode which enables it to
send audio to the remote device.
[Off]: The BLUETOOTH power is turned
off and you cannot select the [Bluetooth
Audio] input.
You can connect to a remote device by
using One-touch listening function even
though you have set [Bluetooth Mode] to
[Off].
 [Device List]
Display a list of paired and detected
BLUETOOTH receivers when [Bluetooth
Mode] is set to [Transmitter] (page 25).
 [Bluetooth Standby]
You can set the [Bluetooth Standby] so
that the system can be turned on by a
BLUETOOTH device even when the
system is in standby mode. This
function is only available when you set
[Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: The system turns on automatically
when you establish a BLUETOOTH
connection from a paired BLUETOOTH
device.
[Off]: Off.
If you set [Quick Start Mode] to [Off] and
[Bluetooth Standby] to [On], the system
can be turned on by a BLUETOOTH device,
but BLUETOOTH connection fails.
 [Bluetooth Codec - AAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: Enable AAC codec.
[Off]: Disable AAC codec.
 You can enjoy high quality sound if the
AAC is enabled. In case you cannot listen
to AAC sound from your device, select
[Off].
 If you change the [Bluetooth Codec - AAC]
setting when a BLUETOOTH device is
connected, the codec setting is only
reflected after the next connection.
 [Bluetooth Codec - LDAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: Enable LDAC codec.
[Off]: Disable LDAC codec.
If you change the [Bluetooth Codec - LDAC]
setting when a BLUETOOTH device is
connected, the codec setting is only
reflected after the next connection.
[Bluetooth Settings]
Note
Note
Note
Note