EasyManua.ls Logo

Sony HT-XT3 - Unit Lock and Brightness Control; Standby Power Saving Settings

Sony HT-XT3
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
GB
HT-XT3
4-558-561-13(1)
D:\NORM'S JOB\SONY HA\SO150002\HT-XT3 (PMRF 02)\4558561131_GB
(CEK)\060OTH.fm
masterpage:
Right
Other Functions
Deactivating the touch
keys on the unit (Child
Lock)
You can deactivate the touch keys on
the unit (except for ) for preventing
misoperation, such as child mischief.
Be sure to use the touch keys on the unit
to perform this operation.
While holding INPUT, touch VOL –,
VOL + and VOL – in sequence.
“LOCK” appears in the front panel
display.
You can only operate the system by
using the remote control.
To cancel, while holding INPUT, touch
VOL –, VOL + and VOL – in sequence.
“UNLCK” appears in the front panel
display.
Changing the brightness
You can change the brightness of the
front panel display and blue LED
indicator.
Press DIMMER repeatedly.
You can adjust the brightness in
3 levels.*
* The brightness for “DIM1” and “DIM2”
settings are the same.
The front panel display is turned off when
“DIM2” is selected. It turns on
automatically when you press any
buttons/touch keys, then turns off again if
you do not operate the system for about
10 seconds. However, in some cases, the
front panel display may not turn off.
Saving power in Standby
Mode
Check that you have made the following
settings:
[Bluetooth Standby] is set to [Off]
(page 25).
[Control for HDMI] in [HDMI Settings] is
set to [Off] (page 26).
[Quick Start Mode] is set to [Off]
(page 27).
[Remote Start] is set to [Off] (page 28).
Note

Table of Contents

Other manuals for Sony HT-XT3

Related product manuals