Sony HT-XT3 - Network and BLUETOOTH Connection Issues

40
GB
HT-XT3
4-558-561-13(1)
D:\NORM'S JOB\SONY HA\SO150002\HT-XT3 (PMRF 02)\4558561131_GB
(CEK)\070ADD.fm
masterpage: Left
 Tuner-related devices: up to
4 devices
 Audio system (receiver/
headphones): up to 1 device
(including this system)
The system cannot connect to the
network.
 Check the network connection
(page 16) and the network settings
(page 27).
You cannot connect your PC to the
Internet after [Wi-Fi Protected Setup
(WPS)] is performed.
 The wireless settings of the router
may change automatically if you
use the Wi-Fi Protected Setup
function before adjusting the
settings of the router. In this case,
change the wireless settings of your
PC accordingly.
The system cannot connect to the
network or the network connection is
unstable.
 Check if the wireless LAN router is
on.
 Check the network connection
(page 16) and the network settings
(page 27).
 Depending on the usage
environment, including the wall
material, radio wave reception
conditions, or obstacles between
the system and the wireless LAN
router, the possible communication
distance may be shortened. Move
the system and the wireless LAN
router closer to each other.
 Devices that use a 2.4 GHz
frequency band, such as a
microwave, BLUETOOTH, or digital
cordless device, may interrupt
communication. Move the system
away from such devices, or turn off
such devices.
 The wireless LAN connection may
be unstable depending on the
usage environment, especially
while using the BLUETOOTH
function of the system. In this case,
adjust the usage environment.
The wireless router you want is not
shown in the wireless network list.
 Press BACK to return to the previous
screen, and try [Wireless
Setup(built-in)] again. If the wireless
router you want is still not detected,
select [New connection registration]
from the network list, then select
[Manual registration] to input a
network name (SSID) manually.
BLUETOOTH connection cannot be
completed.
 Make sure that the blue LED
indicator is lit (page 42).
 Make sure the BLUETOOTH device
to be connected is turned on and
the BLUETOOTH function is
enabled.
 Move the BLUETOOTH device closer
to the unit.
 Pair this system and the
BLUETOOTH device again. You may
need to cancel the pairing with this
system using your BLUETOOTH
device first.
 Set [Bluetooth Mode] to [Receiver]
or [Transmitter] (page 25).
Network connection
Wireless LAN connection
BLUETOOTH device