26
GB
HT-XT3
4-558-561-13(1)
D:\NORM'S JOB\SONY HA\SO150002\HT-XT3 (PMRF 02)\4558561131_GB
(CEK)\050SET.fm
masterpage: Left
LDAC is an audio coding technology for
“High Resolution (Hi-Res) Audio”
developed by Sony, which operates at
990 kbps to 303 kbps* with the sampling
rates of 96/88.2/48/44.1 kHz. It is
optimized for high sampling rate and high
bit rate coding, and allows for a
transmission of Hi-Res Audio content even
through BLUETOOTH connection while
maintaining sound quality almost
equivalent to its original under a stable
wireless network environment. It also
provides high coding efficiency at low
sampling rates and low bit rates, enabling
a CD quality audio transmission even with
an unstable wireless connection.
* When the sampling rate is 96 kHz or
48 kHz, it operates at 990 kbps to
330 kbps. When the sampling rate is
88.2 kHz or 44.1 kHz, it operates at
909 kbps to 303 kbps.
[Wireless Playback Quality]
You can set transmission data rate of
LDAC playback. This function is only
available when you set [Bluetooth
Mode] to [Transmitter] and [Bluetooth
Codec - LDAC] to [On].
[Auto]: The data rate is automatically
changed depending on environment. If
audio playback is unstable in this
setting, use other three settings.
[Sound Quality]: The highest data rate is
used. Sound is sent in the higher quality,
however audio playback sometimes
may become unstable when the link
quality is not good enough.
[Standard]
: The middle data rate is
used. It balances both sound quality
and playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
[OSD Language]
You can select the language you want
for the system on-screen display.
[HDMI Settings]
[Control for HDMI]
[On]
: Turns on the [Control for HDMI]
function. You can operate mutually
between device that are connected with
an HDMI cable.
[Off]: Off.
[Audio Return Channel]
This function is available when you
connect the system to a TV’s HDMI IN
jack that is compatible with the Audio
Return Channel function and [Control
for HDMI] is set to [On].
[Auto]
: The system can receive the
digital audio signal of the TV
automatically via an HDMI cable.
[Off]: Off.
[Standby Through]
You can output HDMI signals to the TV
even when the system is in standby
mode. This function is available when
you set [Control for HDMI] to [On].
Default setting:
[Off] (Europe models only)
[Auto] (Other models)
[Auto]: Outputs signals from the HDMI
OUT (ARC) jack when the TV is turned on
while the system is in the standby
mode. This setting saves power in the
standby mode compared to the [On]
setting.
[On]: Always output signals from the
HDMI OUT (ARC) jack when the system is
in standby mode. If you connect a TV
other than “BRAVIA”, we recommend
you to select this setting.
Tip
[System Settings]
To Next Page
Loading...
