Sony ICF-SW1000TS - Setting the Clock

Basic Operations
Basic Operations
5
EN
FWD
TIME SET
ENTER
123
456
789
0
Setting the clock
1 Press and hold TIME SET •
ENTER while pressing HOUR or
MIN repeatedly until the correct
time is displayed.
Each time MIN (¿ or ÷) is pressed,
the minute will decrease (¿) or
increase (÷) by one minute. Each
time HOUR (
–
1¿ or ÷1
+
) is pressed,
the hour will decrease (
–
1¿) or
increase (÷1
+
) by one hour.
Press and hold the button to decrease
or increase rapidly.
2 Release TIME SET • ENTER.
The “:” starts flashing and the clock
operates.
1
1,2
+
To display the clock
Press EXE to display the clock while operating the
radio or the cassette. The current time appears for
about 10 seconds and then the previous display
returns. However, the clock cannot be displayed
while scan tuning.
While the clock is displayed, press EXE again to
return to the previous display.
Note
You cannot set the clock while operating the radio or the
cassette.
Press RADIO POWER ON/OFF to turn off the radio, or
press p to stop the tape.
Tips
• The clock is displayed in
24-hour indication.
• Press TIME SET•
ENTER to stop the
flashing of “0:00”.
• To set the clock
accurately, release TIME
SET • ENTER at the
time of the tone.
Set the clock when you initially insert the
batteries or when the clock is reset at which
time “0:00” flashes.