Sony ICF-SW1000TS - Changing the MW Channel Step for Use in Foreign Countries

Radio
Radio 19
EN
Changing the MW channel step for use in
foreign countries
The MW channel step of this unit is factory-
set to 9 kHz. The channel step differs
depending on the area to match the frequency
allocation system of the country. Change the
MW channel step as necessary.
North and South American countries:
10 kHz
Japan, Europe, and other countries:
9 kHz
Notes
• When you have entered
the wrong MW channel
step in step 3, press
DIRECT to cancel the
current entry and enter
the correct value.
• “TRY AGAIN!” flashes
when the MW channel
step entered is invalid
(i.e., not 9 or 1 and 0).
Repeat from step 2
again.
• Complete each button
operation in steps 2 to 4
within 10 seconds. If
the clock display
returns, repeat from
step 2 again.
1 Turn off the radio.
2 Press DIRECT.
3 Press the numeric buttons (1, 9 and 0) to enter the
desired MW channel step (9 or 1 and 0).
4 Press EXE.
The MW channel step flashes for about 3 seconds and
then the clock display returns.
AM
kHz
FWD
AM
kHz
FWD
123
456
789
0
DIRECT
EXE