Select from History
Previous
Enter Number/Address
Select from Phone Book
Connect
IP:192.168.0.11 5/11/2008 13:00
Detailed Dial
Dial to:
Line I/F
Communication
Bit Rate
Number of Lines
Home
1Mbps
IP
1B (64K)
SaveConnect
Cancel
History
Phone Book
Connect
Camera
5/11/2008 13:00IP:XXX.XXX.XXX.XXX
Home
AAA
Ready
1. To begin with 2. Let’s connect
Press ENTER after each selection to proceed.
1
Select “Connect.”
2
Select “Enter Number/
Address.”
3
Select the Line I/F.
The Line I/F
cannot be selected
depending on the
system setup.
Connect
Camera
5/11/2008 13:00IP:XXX.XXX.XXX.XXX
Home
AAA
Ready
4
Enter the IP address or ISDN line
number
of a remote party.
5
Select “Connect” and press
ENTER, or press
.
The number is dialed, and the
system establishes connection.
ISDN will be supported in version 1.41 and later.
Turn on your HD Visual Communication System and TV monitor,
and check the following to ensure that connection is possible.
Is the picture of your camera (local picture) on the monitor screen?
Is the IP address of the local system or the ISDN line number
displayed?
Notes:
Connection to a remote party is not possible if neither the IP address
ˎ
nor ISDN line number
is not displayed.
You can hide the IP address of the local system using the setup menu.
ˎ
Main indicators that appear during
communication
Controlling a remote camera.
Local microphone is turned off.
Presentation (transmission) is being executed.
Presentation (reception) is being executed.
Local party has drawing rights for annotation
(function for writing on the display via a pen tablet).
1 2 4 5 3
This section describes how to call a remote party that is not registered in the Phone Book.
© 2013 Sony Corporation
HD Visual Communication System PCS-XG100/XG77/XG100S/XG77S
Quick Connection Guide
For details on operations, refer to the Operating Instructions (stored in the supplied CD-ROM).
4-455-812-13 (1)
To Next Page
