Sony KV-25F3A - BE-3 D Self Diagnostic Software

— 33 —
KV-25F3
The identification of errors within the BE-3D chassis is triggered in 1 of 2 ways :- 1: Bus busy or 2: Device failure to respond to
IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report
with continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is
found to be faulty the relevant device number will be displayed through the led (Series of flashes which must be counted) See
Table 1, non fatal errors are reported with this method.
Table 1
4-3. BE-3D SELF DIAGNOSTIC SOFTWARE
Flash Timing Example : e.g. error number 3.
Stby LED
ON
ON ON
OFF
OFF
RORRE
DEL
RORRE
TNUOC
rorreoN00
esnopserscriShtiwdesufnocebyam(dewollatoN
)!hsalf
10
>EMITYNA<pirttiucricnoitcetorP20
>YLNOPUREWOP<WOLLCSCII30
>YLNOPUREWOP<WOLACSCII40
>YLNOPUREWOP<WOLLCS&ADSCII50
REWOP<egdelwonkcaonrellortnocamorhC/elgnuJ
>YLNOPU
60
>YLNOPUREWOP<egdelwonkcaonhctiwSoediV70
egdelwonkcaonrenuT80
egdelwonkcaonPSM90
egdelwonkcaonMVN01
>YLNOPUREWOP<woLDXTL3M11
>YLNOPUREWOP<woLDXRL3M21
>YLNOPUREWOP<woLELBANEL3M31
>YLNOPUREWOP<woLDXR&DXTL3M41
>YLNOPUREWOP<liaftsettxeTtcapmoC51
tesernorewoptonnachctiwsVA
>noitasilaitinIsissahC<
61
dekcehcnorewoplaitiniretfa(elgnujesilaitinitonnaC
>noitasilaitinIsissahC<-)KOtuo
71
-V5+YBTS(noitasilaitiniretfaliafegdelwonkcaMVN
)!orcimsaemas
81
PUREWOP<egdelwonkcaonhtiwsecivedelpitluM
>YLNO
91
-LATAFEBTONYAM<eruliafemit-nurtxettcapmoC
>REDAERRORRENOYALPSID
02
kcehcpurewopretfaeruliafesnopserHCTIWSVA
)tsetV9+(
12
retfaeruliafesnopserrellortnocAMORHC/ELGNUJ
)tsetV9+(kcehcpurewop
22
)tsetV5+(dnopsertonseodtxettcapmoC32
YALPSID-LATAFEBTONYAM<eruliafemit-nurPSM
>REDAERRORRENO
42
emit-nur(dnesatadretfatuoemitwolkcolCsubL3M
)eruliaf
52
rewopta(dnesatadretfatuoemitwolkcolCsubL3M
)kcehcpu
62
dnesatadretfatuoemitwolkcolCsubL3M
)noitasilaitinita(
72