Sony LH61 - Program Execution

55
English
5-14-4. Program execution
Select the program execution mode.
Operating Procedure
Display
INC
mm
INC
mm
INC
mm
BH PRG REF
BH PRG REF
INC
mm
INC
mm
INC
mm
BH PRG REF
INC
mm
INC
mm
INC
mm
BH PRG REF
BH PRG REF
INC
mm
INC
mm
INC
mm
BH PRG REF
Call the program.
Move the scale so that the X, Y and Z axes
display “0”.
An arrow indicator appears on the moved
axis.
When the value approaches “0”, the arrow
indicator flashes. When the value is equal
to “0”, the arrow indicator goes out.
(Determination of equality to “0” is within 3
counts.)
Call the program.
Move the scale so that the X, Y and Z axes
display “0”.
Call the program.
End of the program.
Press the Cancel key to end the program.
Note
• If the scale is moved at high speed, the
arrow indicator may not go out even
though “0” is passed.
• See 5-14-8 for the range in which the
arrow indicator starts to flash.
H
START
H
START
H
START
After approx. 2 seconds
After approx. 2 seconds
BH PRG REF
BH
PRG REF
BH PRG REF
After approx. 2 seconds
Present value display
Flashes
Flashes
Lights up
Flashes
Flashes
Lights up
Flashes
Lights up
Off