51
English
4-3-4. Peak-hold function
• Stores the maximum, minimum, and peak-to-peak
(maximum–minimum) values of the measured values.
• The above mentioned measuring mode is set using the
keys on the front panel.
• The device starts storing values on receiving a start
signal input from pin 0 of the terminals, or when the
reset key has been pressed.
4-3-3. Result evaluation
• Go/No Go test is carried out by comparing data from the
current measuring mode (current value, maximum value,
minimum value, or peak-to-peak value) to the comparator
upper and lower limits.
• This result is displayed on the front panel and output from
the terminals (See P60 “6. Terminals I/O”.).
Result
High
Go
Low
Display
>
\
?
Condition
Data > upper limit
Upper limit
>
data > lower limit
Lower limit
>
data
=
=
Operation
Start on “L” (ON) signal
from pin 0 of the terminals
Reset key is pressed
Result
Starts storing from the current value.
Starts storing from zero.
When a preset value is set the
device starts storing from the preset
value.
To Next Page
Loading...
