xvii
Downloading Example
After replacing the main camera board, you need to write that data back
into the camera on the new board.
1. Begin by clicking on “Load of Data” above the table.
2. From the Data Load screen, select the file (named by serial number)
that you want to load into the camera.
3. From the same Data Load screen, click the Load button. This will bring
you back to the Data handling window but the data has not been loaded
yet.
4. From the Data handling screen, download the data into the camera by
clicking the Write button.
This completes the Upload/Download process.
To Next Page
Loading...
Need help?
General
