Sony MDP-A1 - Karaoke Setup and Troubleshooting; TV and Stereo Connections for Karaoke

3 Turn on the TV and stereo system
TV: Set to “Video”.
Stereo system:
Turn on the amplifier or receiver and
select CD or AUX for audio output.
yf Adjust the microphone volume
ECHO <@ anc
@
MIC LEVEL control
Adjust the microphone volume with the MIC LEVEL
control (the inner knob).
Sound from a microphone cannot be output when the
player is connected to the amplifier with a Fiber Optical
Cable. To output sound from a microphone, use an
Audio Cable (Red & White plugs) for connection.
If the output is distorted
The output may sound distorted when listening through
your TV speakers. Correct this by setting the ATT
(Attenuator) switch on the rear panel of the player to
ON. (This will lower the volume which should now be
adiusted with the volume control on the TV.
5 Place a disc on the tray
Carefully center a single disc on the tray. The
disc will not play if it is not seated property.
Always insert one disc at a time. inserting
more than one may damage the player.
6 Choose a selection to play
oO9 ¢ The disc tray closes automatically and
D ® @© play starts. y ¥
® ®©
@
¢ Press PLAY ({ ®) or push the disc tray to playback
trom the beginning of the disc (side A of the LD).
° To choose a selection on side B of the LD, press
DISC SIDE 8, then press the number key(s).
if the picture on the TV flickers
The picture appearing on the TV screen may flicker when
listening through your TV speakers and the MIC volume is
set too high. Correct this by setting the ATT (Attenuator)
switch on the rear panel to ON, or lower the MIC LEVEL.