Sony MDP-A1 - Connecting to Television; Standard TV Hook-Up

How to Connect the Television
To play LOs or CDVs, hook up a television to the Multi Disc Player. Take out the supplied audio/video connecting cable
(yellow, red and white plugs). Use this to connect the player to the television. Once you have hooked-up the television,
set the input selector on the TV to “Video”. Before connecting or disconnecting any of the cables, turn off all equipment.
Television Hook-Up
om 423
TTNNSTIT
Tui
Television
YC-15VS
Video
Out
Cable
(nol
s
pplied)
EST
S
Video
In**
m.. Video in
ami (Yellow plug)
B> Audio In
ore (ROG &
TP white plugs)
Audio/Video Cable (supplied
Television/VCR Hook-Up
Connect to the extemal video/audio inputs of a VCR.
Connecting Precautions:
° Make sure all equipment is turned off before connecting or disconnecting any cabies.
¢ Connection methods may differ; when in doubt about a connection consult the TV or VCR manufacturer’s manual.
¢ If the sound or picture is disturbed by noise, try moving the equipment farther apart.
° Firmly insert plugs into the jacks. A loose connection may cause noise.
° To prevent later interference with TV broadcast reception, turn off all equipment connected but not currently in use.
* if the TV only has a monaural phono jack for audio input, use a VMC-910MS/915MS Connecting Cable (not supplied).
+ if your TV has an S Video Input jack, obtain a YC-15V S$ Video Connecting Cable, and use this instead of the supplied
video cable to connect your television to the S VIDEO OUT connector on the Multi Disc Player.
installation and Connection 17