(jY
Additional
Information
Troubleshooting
If
you
run
into any problems using this headphone system, use the following
checklist. Should any problem persist, consult your nearest Sony dealer.
Symptom
No
sound
Cause
and
remedy
..
Check the connection between the processor
and
the AV component.
..
Check that the signal is
not
being
input
to the digital
out
jack
by
mistake when
digital
input
is selected.
..
Check that the connected AV component's optical digital
output
is set to "ON"
when
selecting digital input.
..
Turn
on
the AV component connected to the processor,
and
start the playback.
..
Check that the INPUT SELECT switch
on
the processor is set to the
component you
want
to listen to.
..
If
you
connect the processor to
an
AV componentusing the headphone jack,
raise the volume level
on
the connected AV component.
..
Make sure you are wearing the headphones correctly.
..
Raise the headphone volume.
..
The headphones' POWER indicator goes
off.
• Charge the rechargeable battery
if
it
is weak,
or
replace alkaline batteries
with
new
ones.
If
the POWER indicator is still off after charging the battery,
take the headphones to a Sony dealer.
..
You are trying to
playa
DTS
audio track
on
a DVD device
that
does not
support
DTS.
• Either use a DVD device thatsupports
DTS,
or select a Dolby Digital
or
PCM
audio
track.
..
You are playing back a DVD disc recorded
in
DTS
when
DTS
digital
output
setting for the DVD device (including game machines) is "OFF."
• See the instruction manual of
your
DVD device,
and
change the
DTS
digital
output
setting to "ON."
..
You are playingback a DVD disc recorded in
DTS
when
the DVD device
(including game machines)
and
the processor are analog-connected.
• Use the digital connection. (Analog
sound
may
not
be
output
from the DVD
device.)
..
The processor's ID is not set for the additi.onal headphones.
..
Additional headphones are being charged.
• Remove additional headphones from the processor.
(Continued)
Additional
Information
To Next Page
Loading...
