Sony MDS-JA20ES User Manual

Recording on MDs
16
EN
P.HOLD
DIGITAL REC LEVEL
/ANALOG OUT LEVEL +/–
18
W
23
NUM
!
A˜B
17
V
22
–
CHAR
?
REPEAT
WRITE CLEAR
16
U
21
Z
NAME
/
> 25
19
X
24
.
(
P.HOLD
A.SPACE
+
STANDBY
=
START
P
STOP
T.REC MUSIC SYNC
REC-IT
20
Y
25
,
)
M.SCAN
0
=
·
)
+ r
P p
CD-SYNC
CD PLAYER FADER
DIGITAL REC LEVEL
/ANALOG OUT LEVEL
4 Stop playing the program source.
5 To start recording, do the procedure starting from
Step 11 in “Recording on an MD” on page 10.
z The Peak Hold Function freezes the level meter
display at the highest level reached by the input
signal
To turn on the Peak Hold Function by Setup Menu 06
setting
1 While the deck is stopped, press MENU/NO twice to
display “Setup Menu”.
2 Turn AMS to select “Setup 06”, then press AMS.
3 Turn AMS to select “P.Hold On”, then press AMS.
4 Press MENU/NO.
To turn on the Peak Hold Function using the remote
Press P.HOLD to display “P.Hold On.”
To turn off the Peak Hold Function, select “P.Hold Off”
in Step 3 above. (Or press P.HOLD on the remote to
display “P.Hold Off”.)
Adjusting the analog recording level
1 Do Steps 1 to 9 in “Recording on an MD” on
pages 9 and 10.
2 Play the portion of the program source with the
strongest signal level.
3 While monitoring the sound, turn ANALOG REC
LEVEL L/R to adjust the recording level.
If the output level of the connected component is
too low, it may not be possible to set the
recording level to maximum.
4 Stop playing the program source.
5 To start recording, do the procedure starting from
Step 11 in “Recording on an MD” on page 10.
Adjusting the Recording Level
You can adjust the recording level before starting
recording.
Adjusting the digital recording level
You do not normally need to adjust the digital
recording level. The level is adjusted mainly when the
level of the source is low.
1 Do Steps 1 to 9 in “Recording on an MD” on
pages 9 and 10.
2 Play the portion of the program source with the
strongest signal level.
3 While monitoring the sound, turn DIGITAL REC
LEVEL (or press DIGITAL REC LEVEL/
ANALOG OUT LEVEL +/–) to adjust the
recording level so that the peak level meters reach
their highest point without turning on the OVER
indication. Occasional lighting of “OVER” is
acceptable.
If the digital signal level of the source is too low,
it may not be possible to set the recording level to
maximum.
OVER indication
≠ AMS ±
MENU/NO
DIGITAL REC LEVEL
g
0)
§
( Pp r
ANALOG REC LEVEL L/R

Sony MDS-JA20ES Specifications

General

Brand	Sony
Model	MDS-JA20ES
Category	MiniDisc Player
Language	English