Editing Recorded MDs
51
EN
g
0)
§
(
Pp r
≠ AMS ±
MENU/NO YES
Undoing the Last Edit (Undo
Function)
You can use the Undo Function to cancel the last edit
and restore the contents of the MD to the condition that
existed before editing was done. Note, however, that
you cannot undo an edit if you do any of the following
after the edit:
• Press the r REC button on the deck.
• Press the r button, the MUSIC SYNC button, or the
CD SYNC STANDBY button on the remote.
• Update the TOC by turning off the deck or ejecting
the MD.
• Disconnect the AC power cord.
1 With the deck stopped and no track number
appearing in the display, press MENU/NO to
display “Edit Menu”.
2 Turn AMS until “Undo ?” appears in the display.
“Undo ?” does not appear if no editing has been
done.
3 Press AMS or YES.
One of the following messages appears in the
display, depending on the type of editing to be
undone:
Editing done: Message:
Erasing a single track
Erasing all tracks on an MD “Erase Undo?”
Erasing a part of a track
Dividing a track “DivideUndo?”
Combining tracks “CombinUndo?”
Moving a track “Move Undo?”
Labeling a track or an MD
Changing an existing title
Erasing all titles on an MD
“Name Undo?”
Copying a title
4 Press AMS or YES again.
“Complete!!” appears for a few seconds and the
contents of the MD are restored to the condition
that existed before the edit.
To cancel the Undo Function
Press MENU/NO or p.
To Next Page
Loading...
Need help?
General
