Editing Recorded MDs
48
EN
9 Repeat Steps 7 and 8 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 7 and 8 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press CLEAR.
To enter a space
Press AMS while the cursor is flashing.
10Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press MENU/NO or p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
Copying a track or disc title
You can copy a track or disc title to use it as a title of
another track or the disc title within a disc.
1 Press MENU/NO to display “Edit Menu”.
2 Turn AMS until “Name ?” appears in the display
and press AMS or YES.
3 Turn AMS until “Nm Copy ?” appears in the
display.
4 Press AMS or YES.
5 Turn AMS to select “Disc” to copy the disc title, or
the track whose title you want to copy and press
AMS or YES.
If “No Name” appears in the display
The disc or the track has no name.
6 Turn AMS to select “Disc” for disc title or to
specify the track number to copy a title, and press
AMS or YES.
“Complete!!” appears for a few seconds to indicate
that the copying operation is completed.
If “Overwrite?” appears in the display
The disc or track you selected in Step 6 above has a
title. If you continue the title copying, press AMS
or YES.
To cancel title copying
Press MENU/NO or p.
To Next Page
Loading...
Need help?
General
