Sony MHC-EX5 - Setting the Clock

6
eee See. 2 ae ee ee eG]
inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1 Slide the lid to remove it.
“Na
2 Insert two R6 (size AA) batteries.
Match the + and — to the diagram in the
battery compartment.
3 Slide the lid to replace it.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Chapter 1: Setting Up
Setting the Clock
The built-in clock shows the time in the
display even if the power is off.
Use the buttons on the unit to do this
operation.
ENTER/NEXT MULTI CONTROLLER
indicator
indicator
1 Press CLOCK SET.
The MULTI CONTROLLER indicator,
ENTER/NEXT indicator and the hour
indication begin flashing.
vig .-
<LELL
flashing
2 Set the current hour by turning MULTI
CONTROLLER (+/-) until the correct
hour appears.
r
Va =
<FSL
a
flashing
3 Press ENTER/NEXT.
The minutes indication begins flashing.
flashing
4 set the current minute by turning
MULTI CONTROLLER (+/—) until the
correct minute appears.
flashing
5 Press ENTER/NEXT.
The clock starts running and the upper
dot flashes.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the lower
dot flashes for the last half of a minute
(30 to 59 seconds).
Use the time signal to set the clock
accurately.
flashing
To correct the clock setting
Repeat steps 1 to 5.