You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
l
You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 50).
l
If you perform an editing operation while
playing, be sure not to turn the power off until
“Edit” disappears in the display.
l
Do not move the recorder while “Edit”* is
flashing in the display.
l
The lid will not open until “Edit” disappears
in the display after editing.
l
When group mode is on, editing can be
performed only for the tracks registered into
the selected group.
Labeling/relabeling
recordings
You can name tracks, groups and discs
using the recorder’s character palette.
Available characters
l
Capital and small letters of the English
alphabet
l
Numbers 0 to 9
l !“#$%&()*.;<=>?
@ _ ’ + - ’ , / : _ (space)
Numbers of characters you
can input
Track, group, or disc name: Approx. 200
each
Numbers of characters you
can input in a disc
Numbers/marks: Approx. 1,700
Notes
l
“FULL” appears when you try to enter more
than 1,700 characters on a disc. Enter a shorter
name for the track, group, or disc, or set the
“LPStmp” setting to “OFF” when recording in
MDLP mode so that “LP:” is not be added at
the beginning of the track name (page 26).
l
When labeling a disc which has been recorded
using the group function, make sure group
mode is on in order to prevent the group
management information from being
overwritten by mistake.
l
If you enter the symbol “//,’ between the
characters in disc names such as “abclfdef’,
you may be unable to use the group function.
END SEARCH
MENU/
ENTER
To Next Page
Loading...
