Sony NEX-FS100E - Page 47

47
Recording/Playback
You must set the recording format and
frame rate.
1 Press the MENU button C.
2 Select (CAMERA SET) t [S&Q
MOTION] t [REC FORMAT] with
the SEL/PUSH EXEC dial B.
3 Select a recording format.
You can select one from 1080/50p PS,
1080/25p FX, or 1080/25p FH.
4 Select [FRAME RATE]with the SEL/
PUSH EXEC dial B, and set a desired
frame rate.
You can select one from 50 fps, 25 fps,
12 fps, 6 fps, 3 fps, 2 fps, or 1 fps.
5 Select [ RETURN] t .
Press the S&Q button A, then the START/
STOP button.
Recording starts.
To stop Slow & Quick Motion
recording
Press the START/STOP button again.
To change the frame rate setting
Hold the S&Q button A down for about 1
second, than change the value with the
SEL/PUSH EXEC dial.
Holding the S&Q button A down again for
about 1 second restores the previous setting.
To cancel Slow & Quick Motion
recording
Press the S&Q button A or the MENU
button C during standby.
z Notes
• When you are recording with a slow frame rate,
the camcorder may continue recording for a few
more seconds after you press the START/STOP
button to stop recording.
• You cannot change the frame rate during Slow
& Quick Motion recording. To change the frame
rate, stop current Slow & Quick Motion
recording.
• The time code is recorded in the [REC RUN]
mode during Slow & Quick Motion recording
(p. 79).
• The Slow & Quick Motion mode is canceled
automatically when the POWER switch is set to
OFF, but the frame rate setting is retained.
• You can record sound only at 100% (standard).
• You cannot use the Slow & Quick Motion
function for the simultaneous recording.
• You cannot use the Slow & Quick Motion
function with the standard image quality (SD).
Preparation To record with the Slow & Quick
Motion function