Sony PBD-D50 - Page 81

81
Additional Information
Motion pictures do not play on your
PC.
mDepending on the DVD-ROM,
additional hardware
decoder) for the PC may
be
required. In this case, h
pictures do not play normally.
Please ask the s
a
DVD-ROM.
m Pictures decoded on the MPEG2
built-in decoder cann
ot
on the PC via SCSI.
When using as a DVD player
The power is not turned on.
mIf the POWER indicator is not
check that the AC power
adapt
connected securely. When using the
battery pack, check the
consumption.
mMake sure you use the supplied
AC
power adapter. (Do not use
other AC power adapter.)
mCheck that the HOLD switch is
se
to off.
mDisconnect the AC power adapter
from this unit and the
main
more than one minute. Then connect
the AC power adapter and turn
power on again. If the power
not turned on, disconnect the AC
power adapter and the
ba
and refer to your nearest
dealer.
“
C05 Lo dc InC05 Lo dc In
C05 Lo dc InC05 Lo dc In
C05 Lo dc In” appears in the
front panel display.
mWhen using the battery pack, the
AC power adapter is not connected
to the mains even if the
AC we
adapter is connected to
Disconnect the AC power adapter
from the unit.
mCheck that the AC power adapte
r
connected to the mains, then
disconnect from this unit and
connect again.
There is no picture.
mCheck that the unit is connected
securely.
mThe video connecting cable is
damaged. Replace it with a new
one.
mMake sure you connect the unit to
the video input connector on the TV
(page 25).
mMake sure you turn on the TV.
mMake sure you select the video
input on the TV so that you can
view the pictures from the unit.
There is no sound.
mCheck that the unit is connected
securely.
mThe audio connecting cable is
damaged. Replace it with a new
one.
mMake sure you connect the unit to
the audio input connectors on the
amplifier (page 68).
mMake sure you turn on the TV or the
amplifier.
mMake sure you select the
appropriate position on the
amplifier so that you can listen to
the sound from the unit.
mThe unit is in pause mode or in
Slow-motion Play mode. Press ·
to return to Continuous Play mode.
mThe unit is in Search mode. Press
· to return to Continuous Play
mode.
mWhen you connect the unit to an
amplifier with DIGITAL OUT, set
“DIGITAL OUT” in “INITIAL
SETUP” correctly (pages 69, 70).
mCheck that the headphones plug
connected to the headphones jack is
firmly connected to this unit.
mCheck that the VOL dial is not set to
“0.”
(continued)