Sony R-D-S EON STR-D365 - Getting Started; Unpacking; Hookup Overview

4se
Getting Started
Unpacking
Check that you received the following items with the
receiver:
¢ FM wire aerial (1)
¢ AM loop aerial (1)
¢ Remote controller (remote) (1)
° Size AA (R6) batteries (2)
Inserting batteries into the remote
Insert two size AA (R6) batteries with the + and —- on
the battery compartment. When using the remote,
point it at the remote sensor & on the receiver.
“S when to replace batteries
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the receiver,
replace both batteries with new ones.
Notes
* Do not leave the remote in an extremely hot or humid place.
* Do not use a new battery with an old one.
¢ Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
¢ If you don’t use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
YS a aes |
Hookup Overview
The receiver allows you to connect and control the
following audio components. Follow the hookup
procedures for the components that you want to
_ connect to the receiver on the pages specified. To learn
the locations and names of each jack, see “Rear Panel
Descriptions” on page 16.
Audio/Video
Component Hookups (5)
VCR
Aerial Hookups (5)
AM/FM aerial
Speaker System| ‘0 player
Hookups (6)
CD player
ape/MD deck
Turntable
aU
Before you get started
¢ Turn off the power to all components before making
any connections.
¢ Do not connect the mains leads until all of the
connections are completed.
* Be sure to make connections firmly to avoid hum
and noise.
¢ When connecting an audio cable, be sure to match
the colour-coded pins to the appropriate jacks on the
components: White (left, audio) to White; and Red
(right, audio) to Red.