Sony R-D-S EON STR-D365 - Receiving Broadcasts

Changing the factory setting of a function
button
If the factory settings of the FUNCTION buttons (page
8) don’t match your system components, you can
change them. For example, if you have two CD players
and you don’t have a tape deck or an MD recorder, you
can assign the TAPE/MD button to your second CD
player.
Note that the setting for the TUNER button cannot be
changed.
FUNCTION
Numeric buttons
1 Holding down the FUNCTION button whose
function you want to change (TAPE/MD, for
example).
2 Press the corresponding numeric button of the
component you want to assign to the FUNCTION
button (1 - CD player, for example). For the numeric
buttons, see the table below.
Now you can use the TAPE/MD button to control a
second CD player.
The numeric buttons are assigned to select the
functions as follows:
Numeric button Operates
1 CD player
2 DAT deck
3 MD deck
4 Tape deck A
5 Tape deck B
6 LD player
7 VCR (remote control mode VTR 1*)
8 VCR (remote control mode VTR 2")
9 VCR (remote control mode VTR 3*)
0 TV
* Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
Receiver Operations
To reset the setting to the factory setting
Repeat the above procedure.
Ss 8s ES SS a |
Receiving
Broadcasts
SA
Me
Star
This receiver lets you enter a station’s frequency
directly by using the numeric buttons (direct tuning). If
you don’t know the frequency of the station you want,
see “Receiving broadcasts by scanning stations
(automatic tuning)” on page 10.
Before you begin, make sure you have:
* Connected an FM/AM aerial to the receiver as
indicated on page 5.
¢ Selected the appropriate speaker system. (See
“Selecting the speaker system” on page 7.)
POWER
Function buttons
1. Press POWER to turn on the receiver.
2 = Press TUNER.
The last received station is tuned in.
Press BAND to select FM or AM stations.
4 Press DIRECT.
Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz Example 2: AM 1350 kHz
9 | | | |
Hhbhoee bb6o6
6 When you tune in AM stations, adjust the direction
of the AM loop aerial for optimum reception.
To receive other stations
Repeat Steps 3 to 5.
Key If the STEREO indicator remains off
Press FM MODE when an FM stereo broadcast is received.
(continued)
9%