16
2 While holding the desired Component
Select button pressed, press the button you
want to erase.
When erasing of the “learned” function is
completed, the selected Component Select
button light turns off.
Note
Be sure to press the button you want to erase while
pressing the Component Select Button. If you release
the Component Select button, the Commander changes
to Learning mode.
3 Press SET to finish setting.
To cancel erasing, press SET.
Changing or erasing the function of a
“learned” button
To change the “learned” function, clear it first and
perform Learning again.
To clear the “learned” function of a single
button
2
1,3
Example: To erase the “learned” function from
the Number button 1 in VCR mode
1 Press and hold SET for over 3 seconds.
The SET indicator flashes.
during data
erasing
data erasing
complete
To Next Page
Loading...
Need help?
General
