18
Notes on programming the signals for an
air-conditioner
About seasonal adjustments
If you change the settings of the air-conditioner for
the season, you have to programme the remote
control signals of the new settings on the
Commander.
If the power-on/off operation does not work
correctly
If the Commander can only operate “ON” with one
button and “OFF” with another, while your air-
conditioner’s remote control can operate “ON/
OFF” with a single button, programme the signal
on two buttons of the Commander as follows.
1 Clear the “learned” power-on/off signal on the
programmed button of the Commander.
2 Reprogramme only the power-on signal of the
air-conditioner on the button of the Commander
by following the steps of “Programming Signals
of Another Remote Control- Learning Function”
(page 12).
3 Programme the power-off signal of the air-
conditioner on another button of the
Commander.
The two buttons of the Commander have been
programmed with the power-on signal and the
power-off signal of the air-conditioner respectively,
so that you can operate the air-conditioner with the
Commander.
To Next Page
Loading...
