Sony SAVA-7 - Adjusting Basic Sound

Adjusting the Sound | 4
Although this speaker system's sound quality is
already adjusted, you can change the settings, as you
like, for each surround mode individually. The
following settings, except the balance, remain stored in
their respective surround mode until you change them.
S.WOOFER +/-
BASS +/- ~~ —- TREBLE +/-
BALANCE L/R ~~~
1 Playback a program and choose a surround mode.
2 = Make the following sound adjustments according
to your preference and/or the type of program
you are watching.
7
To press
adjust the super woofer S.WOOFER +/ —
level
adjust the bass level BASS +/—
adjust the treble level TREBLE +/-
adjust the balance BALANCE L/R*
*
Since BALANCE L and R control sound from the left and
right speakers, they have little effect on DOLBY PRO
LOGIC when the source software has a high proportion of
center-channel sound. .
To restore the factory settings
Press RESET while adjusting the level.
Making the adjustment with the main unit
Press SELECT to select the sound you wish to adjust.
Adjust with the +/- buttons.
Pressing SELECT goes through the settings in the
following sequence.
Cc S. WOOFER LEV (super woofer level) =» BASS =>
MASTER VOL (volume) «= TREBLE pe
If INPUT is set to MIX, then the "MIX BALANCE"
indication appears first. :
Enjoying Surround Sound
Using an External Center
Speaker
Since this system incorporates a center speaker (see
page 4), you do not have to connect a center speaker.
However, it is possible to connect a center speaker, if
you already have one, to the EXT CENTER SP
terminal. Be sure to use a speaker with a8 to 16 ohm
impedance for the center speaker.
center speaker
a (optional)
left speaker
Speaker connecting cord
oe
Monaural mini-plug
Consult your dealer about the speaker cord you
require.
When you plug the external speaker cord into the EXT
CENTER SP jack on the left speaker, the built-in center
speakers are muted, and the center channel is output
from the external speaker.
11°