Sony STR-DB930 - Page 10

(--____"--_--“_________--_-_-__-___________„ > ____- ______________ „о“ _ __.__-____________ 1, ee о]
Digital Component Hookups
Connect the digital output jacks of your MD or DAT deck Required cords
to the receiver's digital input jack and connect the digital
input jacks of your MD or DAT deck to the receiver's Optical digital cords (not supplied)
digital
output
jack.
These
connections
allow
you
to
make
Black
Black
digital
recordings
of
a
CDs
played
back
through
vour
DVD (ог LD player) and satellite broadcasts. Audio cords (not supplied)
When connecting a cord, be sure to match the color-coded pins to
the appropriate jacks on the components.
MD or DAT deck
DIGITAL White (0) White (L)
INPUT OUTPUT!
Red (r) —— — j Red (R)
e
© H
@ i
VIOEO 2 VIDEO 1 1240 AUDIO OUT
Notes
• Please note that you cannot make a digital recording of a digital multi channel surround signal.
* To make a digital recording from your CD player, connect-the CD player's digital output directly to the digital input on your MD or DAT
deck. Refer to the instructions supplied with your CD player and MD or DAT deck for details.
* The DVD/LD OPTICAL and COAXIAL jacks are compatible with 32 KHz, 44.1 KHz, 48 kHz and 96 kHz sampling frequencies.
* The TV/SAT OPTICAL IN jack and MD/DAT OPTICAL IN and OUT jacks are compatible with 32 kHz, 44.1 kHz, and 48 kHz sampling
frequencies.
* It is not possible to record analog signals to TAPE and VIDEO with only digital connections. To record analog signals, make analog
connections. To record digital signals, make digital connections.
* Input signals with 96 kHz sampling frequencies to the DVD/LD OPTICAL or COAXIAL jacks. Using other jacks may result in
intermittent sound.
10