Sony STR-DB930 User Manual

MULT CHANNEL DECODING
aro
o о
MDO) VOEO? __ МОО — DVD4D —— TvSAT
ТАРЕ
MODAT co TUNER
I I
Ir
тзт т
recor не SO mass soos
оодооо
VIDEO 3NPUT.
s vio
D эсте
О
вола
— somo nto. SETUP
са
© боре г=9 u
MODE button
Press to select and play another video/audio source in
combination with the selected component.
Each time you press the button, the display changes as
follows:
С? V:XXX —> А:ХХХ — 2ND AUDIO [XXX]*
selected component a
* STR-DB930 only.
———————————Á——— — d
‘© Function indicators
Normally, the indicator above the selected function lights orange.
However, when MODE is used to select a different video (V:XXX)
or audio (A:XXX) source, the video function lights green and the
audio function lights orange. This also occurs when you select
audio components (like PHONO).
[3] INPUT MODE button
Press to select the input mode for your digital
components (DVD/LD, TV/SAT, and MD/ DAT
(STR-DB930) or MD/ TAPE (STR-DB830)).
Each press switches the input mode of the currently
selected component.
Select To
AUTO
Give priority to digital signals
when there are both digital and
Press MODE to display Апа rotate FUNCTION to select
у:ххх Any video source to enjoy with
the audio from the selected
component
A:XXX Any audio source to enjoy with
the video from the selected
component
2ND AUDIO [XXX] An audio source (except
(STR-DB930 only) PHONO) to enjoy in your sub
analog connections. If there are
no digital signals, analog is
room. "SOURCE" selects the
same program source as the main
FUNCTION control**
** Even if 2ND AUDIO [SOURCE] is selected, no sound is output
when the receiver is set to 5.1CH INPUT. Only signals from
components connected to the analog inputs are output through
the 2ND AUDIO jacks. No signals are output from components
connected to only the digital inputs.
• When the 5.1CH INPUT ([4]) is selected, the MODE display
changes as follows:
V:XXX
5.1CH INPUT —]
selected
DIGITAL (OPTICAL)
Specify the digital audio signals
input to the DIGITAL OPTICAL
input jacks
DIGITAL (COAXIAL)
Specify the digital audio signals
input to the DIGITAL COAXIAL
input jacks (DVD/LD only)
ANALOG
Specify the analog audio signals
input to the AUDIO IN (Land К)
jacks
27
ѕиоцеләао хәццашуү >1seg pue spied jo иопе2ој

Sony STR-DB930 Specifications

General

Channels	5.1
Digital Inputs	2 Optical, 1 Coaxial
Tuning Range	FM/AM
Input Sensitivity	150mV (line)
Speaker Load Impedance	8 ohms
Tuner Type	Digital
Frequency Response	10Hz to 100kHz
Total Harmonic Distortion	0.05%
Video Connections	Composite
Surround Sound	Dolby Digital, DTS
Video Inputs	Composite
Video Outputs	1 Composite