There
is
no
sound
from
digital
sources
(from COAXIAL
or
OPTICAL
input
jack).
• Check that the INPUT MODE is not set to
"ANALOG" (page 88).
• Check that ANALOG DIRECT is not set
to on.
• Check to make sure the selected digital
audio input jack is not assigned to other
inputs using DIGITAL ASSIGN function
(page 89).
There
is
no
sound
from
one
of
the
front
speakers.
• Connect a pair
of
headphones to the
PHONES jack
to
verify that sound is
output from the headphones. Ifonly one
channel
is
outputfrom the headphones, the
component may not be connected
to
the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component.
If
both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection
of
the front speaker which
is
not outputting any sound.
• Make sure you have connected
to
both the
Land
Rjacks
of
an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
-
::::s
0-
""I
3
Q)
-
S'
::::s
"NO INPUT" appears
on
the
display
• Check that your component is connected
to
the COAXIAL or OPTICAL jack.
If
no
signal is input through the COAXIAL or
OPTICAL jack, "NO INPUT" appears on
the display and this is not a malfunction.
The left and
right
sounds
are
unbalanced
or
reversed.
• Check that the speakers and components
are connected correctly and securely.
• Adjust the balance parameters using the
LEVEL menu.
There
is
no
sound
from
a
specific
component.
• Check that the component is connected
correctly
to
the audio input jacks for that
component.
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
component.
There
is
no
sound,
no
matter
which
component
is
selected,
or
only
a
very
low-level
sound
is
heard.
• Check that the speakers and components
are connected correctly and securely.
• Check that all speaker cords are connected
correctly.
• Check that both the receiver and all
components are turned on.
• Check that MASTER VOLUME is not set
to
"VOL MIN".
• Check that the SPEAKERS is not set to
OFF (page 30).
• Check that headphones are not connected.
• Press MUTING to cancel the muting
function.
• Check that you have selected the correct
component with the input buttons.
• The protective device on the receiver has
been activated. Tum off the receiver,
eliminate the short-circuit problem, and
tum on the power again.
If you experience any
of
the following
difficulties while using the receiver, use this
troubleshooting guide
to
help you remedy the
problem.
Troubleshooting
conffnued-----------
101
uS
To Next Page
Loading...
