What does no input mean on Sony STR-DH700?
If “NO INPUT” appears on the display of your Sony Receiver, it means no signal is being input through the COAXIAL or OPTICAL jack. Check that your component is connected to these jacks. This display is normal when no signal is present.
How to balance speakers on Sony STR-DH700?
If the left and right sounds are unbalanced or reversed on your Sony Receiver, ensure that the speakers and components are securely and correctly connected. Adjust the balance parameters using the LEVEL menu.
Why is my Sony Receiver humming?
To troubleshoot severe hum or noise from your Sony Receiver, ensure that speakers and components are securely connected. Keep connecting cords away from transformers, motors, TVs, or fluorescent lights (at least 3 meters). Move audio components away from the TV. If the plugs and jacks are dirty, clean them with a cloth slightly moistened with alcohol.
Why is there no sound from a specific component on my Sony Receiver?
If there's no sound from a specific component connected to your Sony Receiver, check that the component is correctly connected to the audio input jacks. Ensure the cords are fully inserted into the jacks on both the receiver and the component.
Why is Dolby Digital not working on my Sony STR-DH700?
If you aren't getting Dolby Digital or DTS multi-channel sound from your Sony Receiver, confirm that the DVD or other source you're playing is recorded in Dolby Digital or DTS format. When connecting a DVD player to the digital input jacks, verify the audio settings (audio output settings) of the connected component.
Why can't I tune into radio stations on my Sony Receiver?
If radio stations cannot be tuned in on your Sony Receiver, check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary. If the signal strength is too weak when using automatic tuning, use direct tuning. Ensure you set the tuning interval correctly when tuning in AM stations with direct tuning. If no stations have been preset or the preset stations have been cleared when tuning by scanning preset stations, preset the stations. Press DISPLAY repeatedly on the receiver so that the frequency appears on the display.
Why is there no sound from surround speakers on my Sony STR-DH700 Receiver?
If there is no sound, or only a very low-level sound is heard from the center/surround/surround back speakers on your Sony Receiver, select a CINEMA STUDIO EX mode. Adjust the speaker level. Make sure the center/surround speakers are set to either “SMALL” or “LARGE”, and the surround back speakers are set to “SINGLE” or “DUAL”.
Why is there no sound from surround back speaker on Sony STR-DH700?
If there is no sound from the surround back speaker on your Sony Receiver, and you are playing discs with Dolby Digital Surround EX logos, select “SB ON” if the disc has no Dolby Digital Surround EX flag.
Why is there no sound from digital sources on my Sony Receiver?
If there is no sound from digital sources (COAXIAL or OPTICAL input jack) on your Sony Receiver, make sure the INPUT MODE is not set to “ANALOG” and ANALOG DIRECT is not set to on. Also, check that the selected digital audio input jack is not assigned to other inputs using the DIGITAL ASSIGN function.
How to enable surround sound on Sony Receiver?
If you cannot get a surround effect from your Sony Receiver, make sure the sound field function is activated by pressing MOVIE or MUSIC. Note that sound fields do not work for signals with a sampling frequency above 48 kHz.
Critical safety warnings for fire and electric shock prevention.
Mandatory safety instructions for appliance usage and maintenance.
Advisories on unauthorized modifications and potential hazards.
Identification and function of buttons and indicators on the front panel.
Details on S-AIR, DMPORT, Antenna, Digital, HDMI, and Speaker connections.
Functions for TV, AV components, input selection, and sound fields.
Guide to installing 5.1 and 7.1 channel speaker systems.
Diagram and instructions for connecting speakers to the receiver terminals.
Diagram showing connections for video components.
Instructions for connecting video and audio signals to a TV.
Connecting Super Audio CD player, CD player, or CD recorder.
Table and guide for connecting various video components.
Diagrams for connecting satellite tuners, DVD players, and Blu-ray players via HDMI.
Instructions for connecting satellite tuners/set-top boxes via component video and digital audio.
Steps to initialize the receiver and return settings to factory defaults.
Procedure to select the active front speaker system (SP A or SP B).
Steps for connecting the optimizer microphone and setting up for calibration.
Details on measurement stages, display indicators, and completion of auto calibration.
List of error codes, their causes, and recommended solutions for calibration issues.
List of warning codes providing measurement results and suggested actions.
Procedure to play test tones and adjust speaker levels for optimal balance.
Detailed explanation of T. TONE, FRT BAL, CNT LVL, SL LVL, SR LVL, SB LVL, SBL LVL, SBR LVL, SW LVL, and D. RANGE.
Explanation of SB OFF, SB AUTO, and SB ON modes for surround back signals.
Using Auto Format Direct (A.F.D.) mode for multi-channel sound.
Choosing sound fields for movies or music to enhance listening experience.
Procedure to preset up to 30 FM and 30 AM stations for quick tuning.
Information on SIRIUS Satellite Radio service, subscription, and packages.
Setting up parental lock using a 4-digit lock code.
Explanation of BRAVIA Sync compatibility and its simplified operations.
Guidelines for handling the receiver safely, including power sources and heat.
Information on power voltage, AC power disconnection, and heat dissipation.
Diagnosing and resolving issues with no sound or low sound from speakers or components.
Troubleshooting no sound from specific speakers or components.
Technical details on power output, distortion, and amplifier section.
Critical safety warnings for fire and electric shock prevention.
Mandatory safety instructions for appliance usage and maintenance.
Advisories on unauthorized modifications and potential hazards.
Identification and function of buttons and indicators on the front panel.
Details on S-AIR, DMPORT, Antenna, Digital, HDMI, and Speaker connections.
Functions for TV, AV components, input selection, and sound fields.
Guide to installing 5.1 and 7.1 channel speaker systems.
Diagram and instructions for connecting speakers to the receiver terminals.
Diagram showing connections for video components.
Instructions for connecting video and audio signals to a TV.
Connecting Super Audio CD player, CD player, or CD recorder.
Table and guide for connecting various video components.
Diagrams for connecting satellite tuners, DVD players, and Blu-ray players via HDMI.
Instructions for connecting satellite tuners/set-top boxes via component video and digital audio.
Steps to initialize the receiver and return settings to factory defaults.
Procedure to select the active front speaker system (SP A or SP B).
Steps for connecting the optimizer microphone and setting up for calibration.
Details on measurement stages, display indicators, and completion of auto calibration.
List of error codes, their causes, and recommended solutions for calibration issues.
List of warning codes providing measurement results and suggested actions.
Procedure to play test tones and adjust speaker levels for optimal balance.
Detailed explanation of T. TONE, FRT BAL, CNT LVL, SL LVL, SR LVL, SB LVL, SBL LVL, SBR LVL, SW LVL, and D. RANGE.
Explanation of SB OFF, SB AUTO, and SB ON modes for surround back signals.
Using Auto Format Direct (A.F.D.) mode for multi-channel sound.
Choosing sound fields for movies or music to enhance listening experience.
Procedure to preset up to 30 FM and 30 AM stations for quick tuning.
Information on SIRIUS Satellite Radio service, subscription, and packages.
Setting up parental lock using a 4-digit lock code.
Explanation of BRAVIA Sync compatibility and its simplified operations.
Guidelines for handling the receiver safely, including power sources and heat.
Information on power voltage, AC power disconnection, and heat dissipation.
Diagnosing and resolving issues with no sound or low sound from speakers or components.
Troubleshooting no sound from specific speakers or components.
Technical details on power output, distortion, and amplifier section.
General| Equalizer | Yes |
|---|---|
| Product color | Black |
| Audio decoders | dts, dts 96/24, dts NEO:6, dts-ES |
| Impedance | 8 Ω |
| RMS rated power | 735 W |
| Audio output channels | 7.1 channels |
| Total Harmonic Distortion (THD) | 1 % |
| Supported radio bands | AM, FM |
| Headphone outputs | 1 |
| Dimensions (WxDxH) | 430 x 157.5 x 322 mm |
| Power requirements | 120 V, 60 Hz |
| HDMI ports quantity | 4 |
| I/O ports | 2 x Anten. 1 x Coax. - in 3 x Compon. - in 1 x Compon. - out 4 x Compos. - in 1 x Compos. - out 1 x DM 3 x HD Compon. - in 1 x HD Compon. - out 3 x HDMI - in 1 x HDMI - out 2 x Opt. - in 1 x Sub. - out |
| Power consumption (standby) | 0.3 W |
| Power consumption (typical) | 240 W |
Weight and Dimensions| Weight | 8000 g |
|---|
To Next Page
