Namlnglpput'f:'
, . ,
~f,.:,~'
You can enter a name
of
up
to 8 characters for
inputs and display it on the receiver's display.
This
is
convenient for labeling the jacks with
the names
of
the connected components.
1 Press the input button to select
the input you want to create an
index name for.
You can also use INPUT SELECTOR on
the receiver.
2 Press AMP MENU.
"I-LEVEL" appears on the display.
3 Press +/+ repeatedly to select
"7-SYSTEM".
4 Press 8
or.
to enter the
menu.
5 Press +/+ to select "NAME IN".
6 Press 8
or.
to enter the
parameter.
The cursor flashes and you can select a
character.
7 Press +/+ to select a character,
then press
./.
to move the
cursor to the next position.
If you made a mistake
Press +1+ until the character you want
to
change flashes, then press
+1+
to select
the correct character.
Tips
-
You
can select the character type as follows
by pressing
./+.
Alphabet (upper case)
-.
Numbers-.
Symbols
-To
enter a blank space,
press.
without
selecting a character.
8 Press
8.
The name you entered
is
registered.
37
US
To Next Page
Loading...
