Tuni'ngJ~to
a
station
directly-
(Direct
Tuning),'
Enter the frequency
of
a station directly by
using the numeric buttons.
1 Press TUNER repeatedly to
select the
FM
or
AM
band.
You can also use INPUT SELECTOR on
the receiver.
2 Press D.TUNING.
3 Press the numeric buttons to
enter the frequency.
Example
I:
FM 102.50 MHz
Select 1• 0 • 2 • 5 • 0
Example
2:
AM 1,350 kHz
Select 1• 3 • 5 • 0
If
you have tuned
in
an AM station, adjust
the direction
of
the AM loop antenna
(aerial) for optimum reception.
4 Press ENTER.
You can also use MEMORYIENTER on
the receiver.
If you cannot tune
in
a station
Make sure you have entered the right
frequency.
If
not, repeat steps 2 to
4.
If
you
still cannot tune in a station, the frequency is
not used in your area.
Chang,-ng
_he
AM::
tuning
seale
.1
~
. .
,.J
•
':::C.
~-
.'"--
~'
::i
(Models of area code
U,
CA only)
You
can change the AM tuning scale to either
9 kHz or
10kHz
using the buttons on the
receiver.
1/(9
TUNING MODE
1 Press
I/O
to turn off the
receiver.
2 While holding down TUNING
MODE, press
I/O.
3 Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to
10
kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
63
US
-
To Next Page
Loading...
