53
US
Tuner Operations
You can enter the frequency of a station
directly by using the numeric buttons.
1 Press D.TUNING.
2 Press the numeric buttons to enter
the frequency, then press .
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 (b 0*)
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
* Press 0 for Mexico model only.
• Adjust the direction of the AM loop
antenna (aerial) for optimum reception
upon tuning to an AM station.
• The tuning scale for direct tuning is shown
below.
*The AM tuning scale can be changed
(page 53).
If you cannot tune to a
station
“– – – .– – MHz” or “– – – – kHz” appears
and then the screen returns to the current
frequency.
Make sure you have entered the right
frequency. If not, repeat step 2. If you still
cannot tune to a station, the frequency may
not be in use in your area.
You can change the AM tuning scale to
either 9 kHz or 10 kHz using the buttons on
the receiver.
1 Press ?/1 to turn off the receiver.
2 While holding down TUNING
MODE, press ?/1 on the receiver.
The current AM tuning scale is
changed to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you
change the tuning scale.
Tuning to a station
directly (Direct Tuning)
Tips
Area FM AM
USA, Canada,
Brazil
100 kHz 10 kHz*
Mexico 50 kHz 10 kHz*
Changing the AM tuning
scale
Notes
?/1
TUNING MODE
To Next Page
Loading...
