Sony TC-366 - Brake Adjustment

11-17. Brake Adjustment
— in STOP mode —
supply brake direction A
torque he cot se saste le
direction B
500~750 g.cm
(6.96~10.4 oz.inch) take-up brake direction C
x torque
1,000~1,800 g.cm
(13.9~25 oz.inch)
400 ~550 g.cm
(5.56~7.65 oz.inch)
Beni
1,600
~
2,200
g.cm
direction
D
(22.
2~30.6
orn
reel table, supply
Adjust the supply brake torque by
expanding or contracting the gap
of the spring.
\e
8.5mm (1142") /
in STOP mode
After having performed the tension
regulator adjustment,
supply brake torque adjustment.
11-18. Tape Slack Check
Place the machine in vertical position
and thread the tape with 7"' reel.
7" reel
FF
STOP
7" reel
FWD (4.8cm/s}
|
STOP
Fig. 11-24 Tape slack check
(Fig. C)}
2) take-up brake
adjustment in the
direction shown
reel table, take-up with C
Ragin } strong
gw sey. See
| weak
@ Adjust by bending
the lever.
p
lever
(A),
S
f
brake
4)
Adjust
by
turning
the
-
spring
screw
so
that
the
distance
shown
with
is
3~4mm
Y
(h~4ho").
After the adjustment, ap-
lever
ply
lock
paint
to
the
screw.
3) take-up brake torque adjustment in
the direction shown with D
@ When the meter reading is more than
the specified value, bend the lever
in the direction shown with arrow.
@ When the meter reading is less than the
specified value, cut off one turn of
the spring end and hook the spring.
Fig. 11-23 Brake adjustment
(1) When changing the function selector knob slowly
from REW to STOP at the end of the tape, be
sure not to slack the tape (See Fig. A).
(2) When changing the function selector knob from
FF to STOP at the beginning of the tape, be
sure not to slack the tape (See Fig. B).
(3) When pulling the instant stop knob in FWD
mode at the beginning of the tape, be sure not
to slack the tape.
(4) When changing the function selector knob from
FWD to STOP at the beginning of the tape at
the 4.8cm/s (1% ips) tape speed, be sure not to
slack the tape (See Fig. C).
2 99.