36
“Controller Network” is available when the menu
is displayed via the controller. (Only when the
controller is connected with the Peer to Peer
connection or Single connection.)
Parallel Remote
Administrator menu
Data management on this unit is configured and
updates are performed.
User Data
Submenu Setting
Network Setting
IP Address Sets the IP address.
Subnet Mask Sets the subnet mask.
Default Gateway Sets the default gateway On or Off.
Address: Sets the default gateway.
Cancel Selects to cancel the setting.
Confirm Selects to save the setting.
Submenu Setting
1Pin to 8Pin You can check the function assigned to
each pin on the PARALLEL REMOTE
connector. For details on the function
assigned to each pin, refer to page 13.
The function assigned to each pin is
fixed. You cannot change the setting.
Submenu Setting
All Data Save Backs up all the current settings.
Cancel: Cancels the backup.
Confirm: Backs up the settings.
When “All Data Save” (page 37)
in “Password” is set to “On,” the
password entry screen is
displayed. Enter the correct
password and select “DONE.”
When “All Data Save” in
“Password” is set to “Off,” the
password entry screen is not
displayed.
The data from User LUT1 to User LUT30
loaded under “User LUT” in the “User
Preset Setting” menu are not backed
up.
All Data Load Loads and applies the backup settings.
Cancel: Cancels the application.
Confirm: Applies the settings.
To Next Page
Loading...
Need help?
General