KV-28WF3/32WF3
29
4-2. TEST MODE 2:
continued on page 30
00 Switch back to normal mode - ‘TT’ mode off
01 Switch service menu on
02 Direct access to Noise reduction
03 Set Volume to 30%
04 Service menu in ‘Service Mode’
05 Service menu in ‘Production Mode’
06 Set Volume to 80%
07 Ageing Mode
08 Shipping Condition
09 Language Reset
10 The ‘TT’ number will be deleted
11 Direct access to Balance
12 Direct access to Hue
13 Display of TV set configuration
14 Production Info Display
15 Read Analog from ROM
16 Save Analog F in NVM
17 This function presets the Labels for the AV sources :
AV1, RGB, AV2, YC2, AV3, YC3, AV4 and YC4.
18 No function
19 No function
20 See ‘TT10’
21 Picture Rotation automatic function (-4) -> (+4) -> 0
22 Error Monitor Display
23 Direct access to Sub Brightness Adjustment
24 Direct access to Sub Colour
25 Status Menu Display
26 Text character selection (Char set 06 -> West Europe)
27 Text character selection (Char set 38 -> East Europe)
28 Text character selection (Char set 40 -> West Europe)
US English
29 Text character selection (Char set 55 -> West Europe)
Tu r kish
30 See ‘TT10’
31 No function
32 No function
33 No function
34 No function
35 No function
36 No function
37 No function
38 Screen Position
39 Reset Programme Table
40 See ‘TT10’
41 Picture Min
42 No function
43 No function
44 No function
45 Set NVM to Protect Mode
46
IR Channel Pressetting Mode. The channel pressetting-
can be done using a Special transmitter.
Sequence: ‘TT46’ -> --PR Number select display appears
Select Prog No. from where the channel
shall be stored.
--> Now TV is waiting for IR sequence <--
--> If no IR transmission starts ‘TT46 is
released after 20 secs <-- ! Note: when ‘TT46’ is active,
any transmission will be interpreted as PROG data !
47 No function
48 No function
49 New Initialize
50 See ‘TT10’
51 Strobo mode is active
52 No function
53 No function
54 Direct access to Velocity Modulation VM (Production use)
55 Slicer High
56 Slicer No
57 Megatext Service Menu ON
58 MTX Small Framing Code Window
Is available by pressing ‘TEST’ button twice, OSD ‘TT’ appears. The functions described below are available by pressing the two numbers. To
release the Test mode 2, press 0, 10, 20 ... twice or switch the TV set into Stand-by Mode. Pressing the two Local Control buttons ( + and - ) during
Power ON will also switch into ‘TT’ mode.
In ‘TT’ mode, it is possible to remove the Menu from the screen by pressing the Speaker Off button once. Pressing the Speaker OFF button a
second time will cause the menu to reappear. The Function is kept even when the menu is not displayed !!.
To Next Page
Loading...
