Sony TRINITRON KV-E2911D - Page 22

| KV-E2511D |
RM-689
5-2. CIRCUIT BOARDS LOCATION
_ Note: The components identified by shading and mark |
: A are critical for safety. Replace only with
part number specified.
Note :
¢ All capacitors are in pF unless otherwise noted.
pF: puF SOWV or less are not indicated except for
electrolytics.
e Indication of. resistance, which does not have one for
rating electrical power, is as follows.
Pitch: 5mm
Rating electrical power: 1/4W
¢ Chip resistor is in 1,/10W.
¢ All resistors are in ohms. kQ= 1000Q2, MQ = 1000k Q
° Bey :
° pet
¢ A: internal component.
° =]: panel designation.
¢ All variable and adjustable resistors have characteristic
nonflammable resistor.
: fusible resistor.
curve B.unless otherwise noted.
e All voltages are in V.
e Readings are taken with a 10MQ digital multimeter.
e Readings are taken with a color-bar signal input.
¢ Voltage variations may be noted due to normal production
tolerances.
adjustment for repair.
oe mmm B + line.
eoSeesety 1 signal path.
— 94 —
Reference information
RESISTOR
COIL
CAPACITOR
: RN
: RC
: FPRD
: FUSE
2 RS
: RB
: RW
: ¥
> LF-8L
: TA
» PS
: PP
: PT
: MPS
: MPP
: ALB
: ALT
: ALR
METAL FILM
SOLID
NONFLAMMABLE CARBON
NONFLAMMABLE FUSIBLE
NONFLAMMABLE METAL OXIDE
NONFLAMMABLE CEMENT
NONFLAMMABLE WIREWOUND
ADJUSTMENT RESISTOR
MICRO INDUCTOR
TANTALUM
STYROL
POLYPROPYLENE
MYLAR
METALIZED POLYESTER
METALIZED POLYPROPYLENE
BIPCLAR
HIGH TEMPERATURE
HIGH RIPPLE
5-3.
KV-E2511D KV-E2511D
RM-689 RM-689
SCHEMATIC
DIAGRAMS
AND
CONTROL
S\
PRINTED
WIRING
BOARDS
—Conductor
Side—
[LINE
FILTER,
DGC]
[POWER
SWITCH]
Foes
—F1 Board—
LFT6Or
>
ca)
re)
“
sew wd OO OOOOOD
—H1 Board—