What to do if my Sony VPL-CX11 Projector power is not turned on?
If your Sony Projector isn't turning on: * Wait about 60 seconds before attempting to turn the power on again if it was recently turned off and on. * Make sure the lamp cover is securely closed. * Ensure the air filter cover is also securely closed.
Why is the LAMP/COVER indicator flashing on my Sony Projector?
If the LAMP/COVER indicator is flashing on your Sony Projector, the lamp cover or the air filter cover might be detached. Attach the cover securely.
Why is the picture from INPUT A connector colored strange on my Sony VPL-CX11 Projector?
If the picture from the INPUT A connector is strangely colored on your Sony Projector, select RGB or COMPONENT for INPUT-A in the SET SETTING menu according to the input signal.
Why does the FAN/TEMP indicator light up on my Sony VPL-CX11?
If the FAN/TEMP indicator lights up on your Sony Projector, the internal temperature is unusually high. Check to see if anything is blocking the ventilation holes.
Why does 'High temp.! Lamp off in 1 min.' appear on my Sony VPL-CX11?
This message on your Sony Projector indicates that the internal temperature is too high. Turn off the power and check to see if anything is blocking the ventilation holes.
What does 'Please replace the lamp' mean on my Sony Projector?
This message on your Sony Projector means that you need to replace the lamp.
Why is my Sony VPL-CX11 picture not clear?
If the picture on your Sony Projector is not clear: * Adjust the focus. * If condensation has occurred on the lens, leave the projector on for about two hours.
Why does my Sony VPL-CX11 Remote Commander not work?
If your Sony Projector's Remote Commander is not working: * Replace the batteries with new ones. * If the front/rear remote control detector is near a fluorescent lamp, change the setting of SIRCS RECEIVER in the SET SETTING menu.
What does 'Please check INPUT-A setting' mean on my Sony VPL-CX11 Projector?
This message on your Sony Projector indicates that the INPUT-A setting in the SET SETTING menu is incorrect. Set INPUT-A correctly.
What does 'Please check INPUT-A setting' mean on my Sony Projector when inputting correct signal?
This message on your Sony Projector indicates that the INPUT-A setting in the SET SETTING menu is incorrect. Select RGB or COMPONENT for INPUT-A in the SET SETTING menu according to the input signal.
General| Resolution | XGA (1024 x 768) |
|---|---|
| Contrast Ratio | 400:1 |
| Lamp Life | 2000 hours |
| Display Technology | 3LCD |
| Aspect Ratio | 4:3 |
| Projection Size | 30 to 300 inches |
| Lamp Type | UHP |
| Weight | 2.9 kg |
| Zoom | 1.3x |
| Input Ports | S-Video, Composite |
To Next Page
