18
VPL-CX61/CX63/CX75/CX76/CX80/CX85/CX86/CX100/CX120/CX125/CX150/CX155/CW125/FE40/FE40L/FH300L/FX40/FX40L/FX51/FX52/FX52L/FW300L/PX35/PX40/PX41
Command Data Remark
POWER 0 Changes the projector’s power status to ‘Standby’.
1 Changes the projector’s power status to ‘Lamp ON’.
POWER ? The following value1s are returned:
0 : Standby
1 : Lamp ON
2 : Cooling state
3 : Warm-up state
4 : Unacceptable period
5 : Projector defect
INPT 1* Changes the projector input to ‘RGB*’.
2* Changes the projector input to ‘VIDEO*’.
3* Changes the projector input to ‘DIGITAL*’.
4* Changes the projector input to ‘STORAGE*’.
5* Changes the projector input to ‘NETWORK*’.
INPT ? The following values are returned:
1*: RGB
2*: VIDEO
3*: DIGITAL
4*: STORAGE*
5*: NETWORK*
AVMT 10 Cancels the projector’s video mute.
11 Sets the projector’s video mute.
20 Cancels the projector’s audio mute.
21 Sets the projector’s audio mute.
30 Cancels the projector’s video + audio mute.
31 Sets the projector’s video + audio mute.
AVMT ? The following values are returned:
11 : Projector video mute ON
21 : Projector audio mute ON
30 : Projector video + audio mute OFF
31 : Projector video + audio mute ON
3-4. PJLink
The following model is equipped with the PJLink class1 protocol.
For details about this protocol, refer to the PJLink specifications published from JBMIA.
You can turn on or off the PJLink protocol and set a password from the Web setting screen > Setup >
Advanced Menu > PJLINK. Up to three controllers can be connected at the same time.
When the authentication setting is changed, the connected controller will be disconnected.
This protocol is set to ON by default.
PJLink class1 corresponding model
VPL-FE40, VPL-FE40L, VPL-FX40, VPL-FX40L, VPL-CX125, VPL-CX155, VPL-CW125, VPL-
FH300L, VPL-FW300L
3-4-1. Command Details
To Next Page
Loading...
