46
VPL-CX61/CX63/CX75/CX76/CX80/CX85/CX86/CX100/CX120/CX125/CX150/CX155/CW125/FE40/FE40L/FH300L/FX40/FX40L/FX51/FX52/FX52L/FW300L/PX35/PX40/PX41
ACK ----- 00h 00h
Undefined Command 01h
Size Error 04h
Select Error 05h
Range Over 06h
Not Applicable 0Ah
Check Sum Error 10h
Framing Error 20h
Parity Error 30h
Over Rub Error 40h
Other Comm Error 50h
NAK
01h
F0h
Item Number
Item
Upper byte
Data
Lower byte
<Table 3>
Data
The await-return time of return value is approx. 200 msec.
m
. This is the case, unless the communications are interfered anyway.
. If standby mode is set as “low”, the main part of a projector will go into
power-saving mode in about 1 minute after standby.
A command is executed by resending, although “Not Applicable” will
return, if a command is sent into power-saving mode.
(VPL-CX100/CX120/CX125/CX150/CX155/CW125)
To Next Page
