47
Removing/Attaching the Projection Lens
Others
1 Remove the projection lens and
adapter from the main unit (page 45).
2 Loosen the two screws to remove the
spacer presser (black) from the
adapter.
3 Depending on the focus condition of
the peripheral area, add or remove a
spacer.
A spare spacer is supplied with the lens.
A spacer is attached inside the spacer
presser (black) of the adapter at the time
of factory delivery.
If the peripheral image is better
focused when the peripheral
focus ring is rotated clockwise all
the way through
Add a spacer.
If the peripheral image is less
focused when the peripheral
focus ring is rotated clockwise all
the way through
Remove a spacer.
When removing or adding the spacer,
handle with care and avoid getting injured.
4 Attach the spacer presser (black) to the
adapter with the two screws.
5 Attach the adapter, front panel, and
projection lens to the main unit.
For details on attachment, refer to
page 44.
6 Perform steps 1 to 4 of the focus
adjustment on page 46.
Adapter
Spacer
Spacer presser
(black)
Screws (2)
Spacer
Note
Spacer
Adapter
Spacer presser
(black)
Screws (2)
To Next Page
Loading...
