How to fix a noisy picture on a Sony VPL-MX20?
If the picture on your Sony Projector is noisy, it could be due to the combination of dots input from the computer and the number of pixels on the LCD panel. Try changing the desktop pattern on the connected computer. If you are inputting a video signal with jitter, use a TBC (Time Base Corrector) to try to reduce video jitter.
How to stop a Sony Projector picture from flickering?
If the picture on your Sony Projector flickers, adjust “Phase” in the Screen menu properly.
What does it mean when the ?/1 key flashes red (2 flashes) on a Sony Projector?
If the ?/1 key on your Sony Projector flashes red with a repetition rate of 2 flashes, the internal temperature is unusually high. Check to see that nothing is blocking the ventilation holes. If the projector is being used at a high altitude, ensure that “High Altitude Mode” in the Setup menu is set to “On.”
Why is the picture from INPUT A colored strangely on my Sony VPL-MX20?
If the picture from the INPUT A connector on your Sony Projector is colored strangely, the setting of “Input-A Signal Sel.” in the Setup menu is incorrect. Select “Computer,” “Video GBR” or “Component” correctly according to the input signal.
How to make the on-screen display appear on a Sony VPL-MX20?
If the on-screen display does not appear on your Sony Projector, the “Status” in the Setup menu has been set to “Off.” Set “Status” in the Setup menu to “On.”
To Next Page
General
