Sony VPL-PHZ12 - Page 7

7
3 Select “User” then press the  key.
The setting items appear.
4 Press the / key to select the item then press the
ENTER key.
5 Press the / key to select the setting value.
6 Press the ENTER key.
The screen returns to the User screen.
For details on each setting, see “Light Output Mode,” and
“Constant Brightness” in the Projection Setting menu
(page 19), “Speaker Setting” in the Function menu
(page 23), “With No Input,” “With Static Signal,” and
“Standby Mode” in the Connection/Power menu (page 25).
If you set “ECO Mode” to “ECO,” or “Standby Mode”(in
“User”) to “Low,” the network control function will be
disabled in standby mode. If the external control is being
performed by using the network or network control
function, do not select “ECO,” or do not set “Standby Mode”
( in “User”) to “Low.”
 Infrared transmitter
About remote commander operation
• Direct the remote commander toward the remote control
receiver.
• The shorter the distance between the remote
c
ommander and the projector is, the wider the angle
within which the remote commander can control the
projector becomes.
• Make sure that nothing obstructs the infrared beam
between the remote commander and the remote control
receiver on the projector.
Note