Sony VPL-PHZ12 - Error Handling; Indicators

44
Indicators
You can check the projector status or abnormality by checking the lighting/flashing status of the ON/
STANDBY indicator and WARNING indicator on the front. If the indicators flash in red, address the problem
in accordance with “Warning indicators and remedies” (page 44).
Operating status indication
Warning indicators and remedies
Error Handling
ON/STANDBY
indicator
WARNING
indicator
Indicator status Operating status Meaning
Standby The power is supplied to the projector and the projector is in a standby
m
ode according to the setting.
Warm-up The projector is warming up after it is turned on.
Power on The projector is ready for projection.
Other standby status The projector is in With No Input (Light Cutoff), Quick Reboot standby
m
ode, or the Speaker Setting is set to “Always On.”
(Off)(Lights in red)
(Off)(Flashes in green)
(Off)(Lights in green)
(Off)
(Lights in orange)
Indicator status The number of flashes Meaning/Remedies
Twice The air filter is not installed securely.
Check how the air filter is attached and install securely.
Three times The light source does not light properly.
Unplug the AC power cord and make sure the ON/STANDBY indicator
t
urns off, then plug the AC power cord into the wall outlet and turn on the
projector.
Six times A strong shock to the projector is detected.
If there is no visible abnormality, unplug the AC power cord and make
s
ure the ON/STANDBY indicator turns off, then plug the AC power cord
into the wall outlet and turn on the projector.
(Flashes
in red)
(Lights
in red)