Sony VPL-VW95ES User Manual

81
Others
Specifications
System
Projection system
SXRD panel, 1 lens, projection system
LCD panel
0.61-inch (15.4 mm)
SXRD panel 6,220,800 pixels
(2,073,600 pixels × 3)
Lens 1.6 times zoom lens (motorized)
f=18.5 mm to 29.6 mm
F2.50 to F3.40
Lamp
200 W Ultra High Pressure Lamp
Projection picture size
40 inches to 300 inches (1,016 mm to
7,620 mm) (measured diagonally)
Acceptable video signals
15 kHz RGB/component 50/60 Hz,
Progressive component 50/60 Hz,
480/60i, 576/50i, 480/60p, 576/50p,
720/60p, 720/50p, 1080/60i, 1080/50i,
1080/24PsF (48i), 1080/60p (HDMI
input only), 1080/50p (HDMI input
only), 1080/24p (HDMI input only),
Composite video
Acceptable computer signals
fH: 19 kHz to 72 kHz
fV: 48 Hz to 92 Hz
Maximum resolution 1,920 × 1,080
(HDMI input only)
For details, see “Preset Signals” (1
page 83).
Input/Output
Y PB/CB PR/CR
Component: phono type
Y with Sync: 1 Vp-p±2 dB sync
negative (75 ohms terminated)
P
B/CB: 0.7 Vp-p±2 dB (75 ohms
terminated)
P
R/CR: 0.7 Vp-p±2 dB (75 ohms
terminated)
HDMI
Digital RGB/Y C
B (PB) CR (PR)
INPUT A
HD D-sub 15-pins
Analog RGB/component:
R/C
R (PR): 0.7 Vp-p±2 dB
(75 ohms terminated)
G: 0.7 Vp-p±2 dB
(75 ohms terminated)
G with sync/Y: 1 Vp-p±2 dB sync
negative (75 ohms terminated)
B/C
B (PB): 0.7 Vp-p±2 dB
(75 ohms terminated)
SYNC/HD: Composite sync input:
TTL level, positive/ negative
Horizontal sync input: TTL level,
positive/negative
VD: Vertical sync input: TTL
level, positive/negative
3D SYNC
RJ45 connector
IR IN
Minijack
TRIGGER
Minijack
Output impedance 1 kilohms
When “Trigger Select” is set to
“Power”
Power on: DC 12 V
Power off: 0 V
When “Trigger Select” is set to
“Anamorphic Zoom”
Anamorphic Zoom: DC 12 V
Other Wide Mode or Power off:
0 V
REMOTE
RS-232C: D-sub 9-pins (female)
General
Dimensions
470 mm × 179.2 mm ×
484.9 mm (18
1
/
2
× 7
1
/
16
×
19
3
/
32
inches) (w/h/d)
Mass Approx. 11 kg (24 lb 4.0 oz)
Power requirements
AC 100 V to 240 V, 3.0 A to 1.3 A,
50/60 Hz
Power consumption
Max. 300 W
Standby mode: 8 W
Standby mode (low): 0.5 W
Operating temperature
5°C to 35°C (41°F to 95°F)
Operating humidity
35% to 85% (no condensation)
Storage temperature
–20°C to +60°C (–4°F to +140°F)
Storage humidity
10% to 90%
Supplied accessories
Remote control RM-PJ21(1)
Size AA (R6) manganese batteries
(2)
AC power cord (1)
Operating Instructions (1)
CD-ROM (ImageDirector3) (1)
3D glasses (2)
Pouch for the 3D glasses (2)

Sony VPL-VW95ES Specifications

General

Lamp type	UHP
Native resolution	1920 x 1080 pixels
Native aspect ratio	16:9
Projection technology	SXRD
Screen size compatibility	40 - 300 \
Projector native resolution	1080p (1920x1080)
Vertical synchronization (max)	92 kHz
Vertical synchronization (min)	48 kHz
Horizontal synchronization (max)	72 kHz
Horizontal synchronization (min)	19 kHz
Bulb power	200 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Power consumption (typical)	300 W
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	35 - 85 %
Product color	Black
Interface	2 x HDMI
Serial interface type	RS-232C
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Consumer Electronics Control (CEC) support	Yes
Light source type	Lamp
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	8 W
Product type	Large venue projector
Focal length range	18.5 - 29.6 mm
Aperture range (F-F)	2.5 - 3.4
Display diagonal	0.61 \
Ethernet LAN	No
Noise level	- dB

Weight and Dimensions

Depth	179.2 mm
Width	470 mm
Height	484.9 mm
Weight	1100 g
Dimensions (WxDxH)	470 x 179.2 x 484.9 mm